Removal And Installation
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
Remove Centre Console Switch Module CCSM. Refer to: [CENTER CONSOLE SWITCH MODULE CCSM]
ORIENTATION VIEW
NOTE:
The graphic shows the back of the component before removal.
Remove the marked part.
On both sides.
Torque: M6, 10Nm
Remove the screws.
Remove the screws.
Disconnect the connectors.
Disconnect the connector.
NOTE:
The graphic shows the back of the component before removal.
Use: Interior trim remover
Remove the marked part.
Torque: M6, 10Nm
Remove the screws.
Lift the marked component up
Disconnect the connector.
Fold marked part aside.
NOTE:
Orientation view
Disconnect the connector.
Release the catches.
Remove the marked part.
INSTALLATION
To install, reverse the removal procedure.