Brake Pads: Remove & Replace
WARNING: This page is about the S60 T5 Inscription, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 1.8 | B | ||
| Front,Both Sides. | 1.0 | B | ||
| Rear,Both Sides | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | Includes: Bleed Base Brake System. | 0.2 | B | |
| One | Includes: Bleed Base Brake System. | 0.3 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One,Front | Includes: Bleed Brakes. | 0.3 | B | |
| One,Rear | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Parking Brake Service Mode | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: WHEEL BEARING: Replace: Includes: Repack Wheel Bearings (where applicable). | ||||
| FWD, Rear,Hub and Bearing Assembly,w/Leaf Spring Suspension,Each | DOES NOT include wheel alignment. Includes: Additional time for use of scan tool to perform this procedure. | 1.2 | B | |
| Front,Hub and Bearing Assembly,Each | 0.5 | B | ||