Brake Pedal [2022, B4204T23; B4204T27 | 2020-2022, B4204T28; B4204T39]: Installation
Make sure that a new bolt is installed.
Do not fully tighten the nut yet.
Install the screw.
Make sure that the sensor is correctly installed.
Tighten the nut.
Torque: Brake pedal, to Pedal box, 18Nm
To install, reverse the removal procedure.
Perform Battery, connecting. Refer to: [BATTERY DISCONNECTING AND CONNECTING]
Perform supplemental restraint system (SRS), post check. Refer to: [SUPPLEMENTARY RESTRAINT SYSTEM]
Calibration according to: Diagnostics / Components / Control modules/ Central Electronic Module (CEM) / Diagnostic sequences / Calibration of brake pedal sensor and brake pedal angle sensor
Calibration according to: Diagnostics / Components / Control modules / Vehicle Dynamics Domain Master (VDDM) / Calibration of regenerative braking system
Perform test drive schedule DSTC/ BCM/ VDDM. Refer to: [TEST DRIVE FORM DSTC/ BCM/ VDDM]