Vacuum Pump, Brake Booster [2016, B4204T11]: Removal
Removal steps in this procedure may contain installation details.
Remove the air filter housing, refer to: AIR CLEANER HOUSING
Loosen the hose clamp.
Remove the hose.
Make sure that the area around the component is clean and free of foreign material.
Make sure that all openings are sealed.
Fold marked part aside.
Remove the fuel pump, refer to: FUEL PUMP
Release the lock.
Disconnect the connector.
Release the catches.
Fold marked part aside.
Remove the screw.
Torque: M6, 10Nm
Loosen the hose clamp.
Remove the hose.
Remove the screws.
Torque: M6, 10Nm
Fold marked part aside.
Be prepared to collect escaping fluid.
Make sure that the area around the component is clean and free of foreign material.
This component is sensitive to "mechanical stresses". If the component has been dropped onto the floor, for example, it must not be installed in a vehicle.
Remove the screws.
Torque: M8, 24Nm
Remove the marked part.
Make sure that a new component is installed.