Brake Pedal [2016-2020, B4204T28]: Installation
Make sure that the component is positioned correctly.
Make sure that a new bolt is installed.
Do not fully tighten the nut yet.
Install the screw.
Make sure that the sensor is correctly installed.
Tighten the nut.
Torque: Brake pedal, to Pedal box, 18Nm
Install the following items:
- Torque: Spring unit, to Pedal box (screw), 11Nm
- Torque: Spring unit, to Pedal box (nut), 7Nm
To install, reverse the removal procedure.
Make sure that the component is positioned correctly.
Perform Battery, connecting, refer to: BATTERY DISCONNECTING AND CONNECTING
Perform supplemental restraint system (SRS), post check, refer to: SUPPLEMENTARY RESTRAINT SYSTEM
Calibration according to: Diagnostics / Components / Control modules/ Central Electronic Module (CEM) / Diagnostic sequences / Calibration of brake pedal sensor and brake pedal angle sensor
Calibration according to: Diagnostics / Components / Control modules / Vehicle Dynamics Domain Master (VDDM) / Calibration of regenerative braking system
Perform test drive schedule, refer to: TEST DRIVE FORM DSTC/ BCM/ VDDM