WASTEGATE Control Valve Adjustment [2009-2010, B6304T2 | 2011-2016, B6304T4]: Adjustment
Remove the right drive shaft. Refer to DRIVE SHAFT RIGHT
Torque: M10, 50Nm
Torque: M10, 50Nm
NOTE:
Turn the adjusting screw counter-clockwise to increase stroke. Turn the adjusting screw clockwise to decrease stroke.
NOTE:
One revolution corresponds to approx. 1 mm stroke.
CAUTION:
Take extra care when handling the component.
- Loosen the nut.
- Adjust to specified average value.
See information about wastegate valve. Refer to WASTEGATE VALVE
CAUTION:
Take extra care when handling the component.
Torque: Pressure regulator, lock nut adjuster rod, 7Nm
- Loosen the nut.
- Adjust to specified average value.
See information about wastegate valve. Refer to WASTEGATE VALVE
Torque: Pressure regulator, lock nut adjuster rod, 7Nm
Repeat the method to verify that the average value is according to specifications.