Vacuum Pump, Brake Booster [2017, B4204T27]: Removal
Removal steps in this procedure may contain installation details.
Remove the fuel pump, refer to: FUEL PUMP
Undo the hose from the connection.
Undo the hose from the connection.
Remove the screws.
Remove the screws.
Remove the part carefully
Remove the screws.
Torque: M6, 10Nm
Make sure that the area around the component is clean and free of foreign material.
Make sure that the mating faces are clean and free of foreign material.
Remove the screws.
Torque: M6, 10Nm
Remove the part carefully
Be prepared to collect escaping fluid.
Make sure that the area around the component is clean and free of foreign material.
This component is sensitive to "mechanical stresses". If the component has been dropped onto the floor, for example, it must not be installed in a vehicle.
Remove the screws.
Torque: M8, 24Nm
Make sure that a new component is installed.
Use lint free cloth.
Make sure that the mating faces are clean and free of foreign material.
Use: Isopropanol, 1161721