Input Shaft Seal [2016, TF-80SC AWD]: Preparation

ORIENTATION VIEW

Courtesy of VOLVO CARS CORPORATION

PREPARATION

Courtesy of VOLVO CARS CORPORATION

Check the value.

Courtesy of VOLVO CARS CORPORATION

WARNING:

Make sure that the component is positioned correctly.

CAUTION:

Place the component on a suitable underlay or support.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

WARNING:

Be prepared to collect escaping fluid.

NOTE:

Note the size of the upper bolts.

NOTE:

Make sure that the component is clean and free of foreign material.

NOTE:

Note the different lengths of the bolts.

Remove the screws.

Torque: Screw to mating surface, transmission, 35Nm
Torque: M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

WARNING:

Wear protective gloves.

NOTE:

Make sure that the component is clean and free of foreign material.

Remove any traces of glue.

Clean the surfaces.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure that the gearbox is in parking mode.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Note the different lengths of the bolts.

NOTE:

Make sure that the component is clean and free of foreign material.

Torque: M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

Torque: Screw to transmission filter, 7Nm

Courtesy of VOLVO CARS CORPORATION

WARNING:

Make sure that the component is positioned correctly.

CAUTION:

Check that the component does not show deformation damage.

NOTE:

Make sure that no component falls off during removal.

Courtesy of VOLVO CARS CORPORATION

Note the value.

Measure from upper flange edge.

Perform on two opposing surfaces.

ORIENTATION VIEW

Courtesy of VOLVO CARS CORPORATION

NOTE:

Note the position.