Wheel Knuckle Front [2017-2018 | 2016, B5254T12, TF-80SC AWD]: Removal

NOTE:

Removal steps in this procedure may contain installation details.

WARNING:

Do not use magnets or magnetic tools close to tooth wheels, drive shafts or wheel hubs. A magnetized tooth wheel will lose its function and generate incorrect signals resulting in fault codes.

NOTE:

Any magnetized tooth wheel, drive shaft or wheel hub must be replaced with a new component.

Remove the front brake disc, refer to: FRONT BRAKE DISC

GLL155547

Courtesy of VOLVO CARS CORPORATION

Torque: M6, 10Nm

GLL155548

Courtesy of VOLVO CARS CORPORATION

Torque: M6, 10Nm

GLL155549

Courtesy of VOLVO CARS CORPORATION

Torque: M5, 5Nm

GLL155551

Courtesy of VOLVO CARS CORPORATION

Torque:Driveshaft to wheel hub (front),

Stage 1: 35Nm
Stage 2: 90°

GLL155356

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that the ball joint ball does not rotate.

Special Tool: 951 2945

Torque: Tie rod end to wheel knuckle, 80Nm

GLL173001

Courtesy of VOLVO CARS CORPORATION

Torque: Ball joint to wheel knuckle, 110Nm

GLL155558

Courtesy of VOLVO CARS CORPORATION

Special Tool: 999 7076

GLL155559

Courtesy of VOLVO CARS CORPORATION

Torque: Wheel knuckle to strut and spring assembly, 110Nm

GLL1010846

Courtesy of VOLVO CARS CORPORATION

Special Tool: 999 7088