Steering Gear [2018, B4204T11, TG-81SC AWD]: Removal

Follow instructions for lifting points body frame, refer to: JACKING POINTS BODY

Courtesy of VOLVO CARS CORPORATION

Courtesy of VOLVO CARS CORPORATION

VEHICLES WITHOUT STEERING COLUMN LOCK 

Courtesy of VOLVO CARS CORPORATION

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Torque:  steering column to steering gear (steering shaft joint), 25Nm

Remove the wheel, refer to: WHEELS

Courtesy of VOLVO CARS CORPORATION

Remove the nuts.

Remove the screws.

On both sides.

Courtesy of VOLVO CARS CORPORATION

Remove the nut.

Torque:  Tie rod end to wheel knuckle, 80Nm

On both sides.

Courtesy of VOLVO CARS CORPORATION

Special Tool: 951 2945  

On both sides.

Courtesy of VOLVO CARS CORPORATION

Remove the nut.

Remove the screw.

1. Torque:  Ball joint to wheel knuckle, 110Nm

2. Torque:Driveshaft to wheel hub (front),

   • Stage 1: 35Nm 
   • Stage 2: 90° 

On both sides.

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Torque:  Brake caliper in steering arm, front, 120Nm

On both sides.

Courtesy of VOLVO CARS CORPORATION

Special Tool: 999 7310  

On both sides.

Courtesy of VOLVO CARS CORPORATION

Special Tool: 999 7076  

On both sides.

Courtesy of VOLVO CARS CORPORATION

Remove the nut.

Torque:  Front stabilizer bar link to stabilizer bar, 70Nm

On both sides.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque:  M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Torque:  Lower torque rod rear left, to transmission bracket, 110Nm

Courtesy of VOLVO CARS CORPORATION

Torque:  Lower torque rod rear right, to Engine mount bracket, 110Nm

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Torque:  Headlamp levelling position sensor to control arm, 6Nm

On both sides.

Courtesy of VOLVO CARS CORPORATION

Courtesy of VOLVO CARS CORPORATION

Loosen the clips.

Disconnect the connectors.

Courtesy of VOLVO CARS CORPORATION

Loosen the screws.

Torque:  Steering gear to subframe, 140Nm

Courtesy of VOLVO CARS CORPORATION

Loosen the screws.

Torque:  Lower arm front to subframe (rear mounting), 175Nm

Courtesy of VOLVO CARS CORPORATION

Use:  Unit lift

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque:Subframe to chassis (Front screws),

• Stage 1: 150Nm 
• Stage 2: 90° 

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

1. Torque:  M10, 50Nm

2. Torque:Subframe to chassis (Rear screws),

   • Stage 1: 150Nm 
   • Stage 2: 90° 

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Courtesy of VOLVO CARS CORPORATION

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque:  M6, 10Nm

Courtesy of VOLVO CARS CORPORATION

Remove the cable harness clips.

Courtesy of VOLVO CARS CORPORATION

Disconnect the connectors.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Courtesy of VOLVO CARS CORPORATION