Removal And Installation

REMOVAL

NOTE:

Removal steps in this procedure may contain installation details.

Drain cooling system, draining, filling, and bleeding, refer to: COOLING SYSTEM - DRAINING, CHARGING AND BLEEDING

Courtesy of VOLVO CARS CORPORATION

NOTE:

Orientation view

Remove Fuel operated auxiliary heater exhaust system, refer to: FUEL OPERATED AUXILIARY HEATER EXHAUST SYSTEM

See information about safety information fuel system, refer to: SAFETY INFORMATION FUEL SYSTEM

Courtesy of VOLVO CARS CORPORATION

WARNING:

Be prepared to collect escaping fluid.

Release the locks.

Undo the hoses from the connections.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque: Combustion heater bracket, to Body, 8Nm

Remove the part carefully

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Note the routing of the lines and hoses.

Disconnect the connector.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

TRANSFERRING COMPONENTS

Perform engine coolant heater, transferring components, refer to: COMBUSTION HEATER, TRANSFER OF COMPONENTS

INSTALLATION

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that the quick release couplings turn properly into locked position.

Courtesy of VOLVO CARS CORPORATION

Install the marked component.

To install, reverse the removal procedure.

Fill cooling system, draining, filling, and bleeding, refer to: COOLING SYSTEM - DRAINING, CHARGING AND BLEEDING

NOTE:

This step is only necessary when installing a new component.

Order and download the appropriate Volvo software.