Power Supply Mode, Status

Status shows the vehicle's power supply mode. Central electronic module (CEM) collects information from relevant modules and sensors and creates the parameter. The information is stored in Central electronic module (CEM) and is distributed to other modules via the communication network that connects Central electronic module (CEM) and the relevant module, e.g. CAN.

The following status modes are available:

• Key removed
• Key recently removed
• Key approved
• Ignition off after Accessory position
• Accessory position
• Accessory position after Ignition on
• Ignition on
• Combustion engine running
• Combustion engine in auto-stop
• Combustion engine in start attempt
• Combustion engine in start attempt at manual start

Status shows the vehicle's power supply mode. Central electronic module (CEM) collects information from relevant modules and sensors and creates the parameter. The information is stored in Central electronic module (CEM) and is distributed to other modules via the communication network that connects Central electronic module (CEM) and the relevant module, e.g. CAN. The value indicates the actual status of the power supply position when the fault code was set. The following status positions are available:

• Key removed
• Key recently removed
• Key approved
• Ignition off after Accessory position
• Accessory position
• Accessory position after Ignition on
• Ignition on
• Running
• Start attempt
• No signal