Other Symbols
- Ignition off, ignition to the 0 position
- Ignition on, ignition to the 2 position
- Parking brake "off"
- Parking brake "on"
- Engage the stated gear position, automatic transmission
- Put automatic transmission in manual mode
- Engage the stated gear position, manual transmission
- Engage the stated gear position, automatic transmission
- automatic transmission - manual shift down
- Wait the specified time
- Engine revs 2000 -2500 RPM
- Add pressure with the stated number of kg
- Check/Ensure
- Listen for noise
- Component is used. Replace with new.
- Two people are required for this task
- Check with mirror
- Protect from moisture
- Repeat the number of times stated
- Temperature 80°C
- Temperature between 80°C and 100°C
- Max temperature 100°C
- Min temperature 80°C
- Drill first layer only
- Drill first two layers only
- Drill first layer only, use 5 mm drill
- Drill first two layer only, use 5 mm drill
- metal inert gas (MIG) welding equipment
- Weld a solid line
- Spot weld
- Turn the component XX degrees in the direction of the arrow, the number of degrees is evident from the image.
- Rotate the component XX turns in the direction of the arrow, the number of turns is evident from the image.
- Do not use impact screwdriver/wrench
- Do not discard the battery
- Steering wheel centered
- Turn the steering wheel 90 degrees in the direction of the arrow
- Turn the steering wheel to the maximum in the direction of the arrow
- Steering lock unlocked position
- Steering wheel locked
- Applies to left-hand drive vehicles. The symbol can also be used as a localization symbol, then with a red ring or a line in the symbol.
- Applies to right-hand drive vehicles. The symbol can also be used as a localization symbol, then with a red ring or a line in the symbol.
- Adjust the headlamps sideways
- Headlight vertical adjustment