Wiring Harness Supplemental Restraint System (SRS) [2016-2018]: Finishing

SECURING THE CABLE FOR THE SRS SYSTEM 

Secure the new cable for the SRS system next to the old cable using a tie strap or similar. Reinstall the connectors.

INSTALLING THE BATTERY LEAD 

Fit the battery's negative cable in accordance with: BATTERY DISCONNECTING AND CONNECTING .

CHECKING AND ADJUSTING THE SRS SYSTEM 

Turn the ignition to position 2.

Check the SRS system to ensure that the warning lamp comes on and stays on while the SRS system performs a self-test. The lamp must go out after a few seconds. If not, perform fault-tracing according to VIDA vehicle communication.

If everything is working, reinstall other components.

Test drive the vehicle.