Removal And Installation
REMOVAL
Removal steps in this procedure may contain installation details.
Remove the following items:
- camshaft seal, refer to: CAMSHAFT SEAL
- the fuel rail, refer to: FUEL RAIL
- Oil trap, refer to: OIL TRAP
Loosen each bolt 2 turns at a time until all bolts are removed.
Take extra care when handling the component.
Take extra care when handling the components.
Remove the marked part.
Take extra care when handling the components.
Remove the marked detail/details.
CLEANING
Take extra care not to damage the mating faces.
Make sure that the oil galleries are clean and free of foreign material.
Make sure that the mating faces are clean and free of foreign material.
Use: Abrasive cloth, 9511024
Use: Isopropanol
Take extra care not to damage the mating faces.
Make sure that the oil galleries are clean and free of foreign material.
Make sure that the mating faces are clean and free of foreign material.
Use: Abrasive cloth, 9511024
Use: Isopropanol
INSTALLATION
The following steps are only necessary when installing a new component.
Perform valve clearance, refer to: VALVE CLEARANCE
Install the marked component.
Use: Engine oil
Install the marked component.
Make sure that the components are positioned correctly.
Make sure that the components are positioned correctly.
Make sure that the components are positioned correctly.
The component must be installed within 5 minutes of applying the sealant.
Use: Chemical gasket, 1161771 Use: Chemical gasket, China 30644521 Use: Chemical gasket, US/CAN 31316814
Make sure that equal pressure is applied to the full length of the component.
Make sure to follow the sequence indicated.
Install the marked component.
Install the screws.
Tighten each bolt 2 turns at a time.
Torque: M7, 17Nm
INSTALLATION
To install, reverse the removal procedure.