Removal And Installation

REMOVAL

Remove vibration damper, refer to: VIBRATION DAMPER

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that the component is positioned correctly.

Courtesy of VOLVO CARS CORPORATION

Refer to: Special Tool: 999 7497

Courtesy of VOLVO CARS CORPORATION

Refer to: Special Tool: 999 7497

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure to turn the component until stop.

Courtesy of VOLVO CARS CORPORATION

Tighten the nuts.

Courtesy of VOLVO CARS CORPORATION

Loosen the screws.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

CLEANING

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure that the component is clean and free of foreign material.

Blow clean using compressed air

CHECK

Courtesy of VOLVO CARS CORPORATION

Check the surfaces for abrasion.

INSTALLATION

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that the component is positioned correctly.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure that a new component is installed.

Tighten the screw.

Torque: M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that the component is positioned correctly.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Only tighten the bolt finger tight at this stage.

NOTE:

Make sure that a new component is installed.

Install the screw.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure to follow the sequence indicated.

NOTE:

Make sure that a new component is installed.

Courtesy of VOLVO CARS CORPORATION

Remove the Special Tool.

BELT TENSIONER ADJUSTMENT

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure that the belt tensioner is aligned to the belt tensioner bracket.

Adjust to the specified value.

Tighten the screw.

Use: Allen key

Torque: M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

NOTE:

The engine is rotated so that the belt assumes its correct position.

Turn the engine

Courtesy of VOLVO CARS CORPORATION

CAUTION:

If the measured value is greater or less than the specified range, all steps in the Adjustment section must be carried out again.

NOTE:

Make sure that the belt tensioner is aligned to the belt tensioner bracket.

Adjust to the specified value.

Install the vibration damper, refer to: VIBRATION DAMPER

Courtesy of VOLVO CARS CORPORATION

Install the marked component.

Install the screws.

Torque: M6, 10Nm

Courtesy of VOLVO CARS CORPORATION

Install the marked component.

Install the screws.

Torque: M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

Install the marked component.

Install the screws.

Torque: M8, 24Nm