Engine Pad Right [2016-2020, B4204T23; B4204T27 | 2016-2020, B4204T28 | 2020, B4204T39]: Removal

NOTE:

Removal steps in this procedure may contain installation details.

Remove the upper torque rod, refer to: UPPER TORQUE ROD

Courtesy of VOLVO CARS CORPORATION

Loosen the screws.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Remove the clips.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Fold marked part aside.

Courtesy of VOLVO CARS CORPORATION

Release the locks.

Release the catches.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Tighten the screw.

Torque: M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Fold marked part aside.

Torque: M6, 10Nm

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Note the position of the component before removal.

Use: Marker pen

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

Torque: Engine mount bracket, to Engine pad, 110Nm
Torque:Engine mount bracket, to Cylinder head, M12,
- Stage 1: 90 Nm
- Stage 2: 130 °
Torque: Engine mount bracket, to Cylinder head, M10, 60Nm

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that new bolts are installed.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.