Catalytic Converter [2016-2020, B4204T27, TG-81SC AWD]: Removal

NOTE:

Removal steps in this procedure may contain installation details.

Courtesy of VOLVO CARS CORPORATION

Loosen the screws.

Remove the marked part.

Remove lambda probe, front, refer to: LAMBDA PROBE, FRONT

Remove rear lambda probe, refer to: LAMBDA PROBE, REAR

Remove the propeller shaft, refer to: PROPELLER SHAFT

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Remove the marked part.

Torque: M6, 10Nm

VEHICLES WITH BYPASS VALVE

Courtesy of VOLVO CARS CORPORATION

NOTE:

The image content (components etc.) may vary depending on equipment level or for other reasons.

Remove the screws.

Fold marked part aside.

Torque: M5, 5Nm

ALL VEHICLES

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Fold marked part aside.

Torque: M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

Remove the nuts.

Torque: M8, 24Nm

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure that a new component is installed.

Loosen the screws.

Torque: Clamp catalytic converter, 20Nm

Courtesy of VOLVO CARS CORPORATION

HINT: It may be necessary to twist or turn the component.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure to follow the sequence indicated.

NOTE:

Make sure that the mating faces are clean and free of foreign material.

Remove the marked part.