Catalytic Converter [2016-2019, B4204T28, TG-81SC]: Removal
Removal steps in this procedure may contain installation details.
Loosen the screws.
Remove the marked part.
Release the locks.
Disconnect the connectors.
Loosen the clips.
Follow instructions for lifting points body frame, refer to: JACKING POINTS BODY
Remove the screws.
- Torque: M8, 24Nm
- Torque: M10, 50Nm
Use a new seal.
Remove the nuts.
Torque: M8, 24Nm
Remove the nuts.
Torque: M8, 24Nm
Remove the nut.
Torque: M8, 24Nm
Loosen the marked detail/details.
Use a new seal.
Remove the marked part.
Remove the nuts.
Torque: M6, 10Nm
Remove the marked part.
Remove the screw.
Torque: M6, 10Nm
Remove the marked part.
Torque: Lambda probe, tightening, 45Nm
Refer to: Special Tool: 999 5543
Torque: Lambda probe, tightening, 45Nm
Refer to: Special Tool: 999 5543
The image content (components etc.) may vary depending on equipment level or for other reasons.
Remove the screws.
Torque: M5, 5Nm
Fold marked part aside.
Remove the screws.
Torque: M8, 24Nm
Fold marked part aside.
Remove the nuts.
Torque: M8, 24Nm
Make sure that a new component is installed.
Loosen the screws.
Torque: Clamp catalytic converter, 20Nm
HINT: It may be necessary to twist or turn the component.
Make sure to follow the sequence indicated.
Make sure that the mating faces are clean and free of foreign material.