Rear Lower Arm [2016-2017 | 2019-2020, TG-81SC | 2019-2020, TG-81SC AWD | 2020, TG-81SD | 2018, B4204T23, TG-81SC | 2018, B4204T23; B4204T27, TG-81SC AWD | 2018, B4204T28, TG-81SC]: Removal

NOTE:

Removal steps in this procedure may contain installation details.

Remove relevant side rear wheel, refer to WHEELS

VEHICLES WITH AIR SUSPENSION

Remove air suspension, rear, refer to: AIR SUSPENSION, REAR

Set the vehicle to Inactive mode, described in user mode, refer to: USAGE MODE

Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Note the position.

Remove the screw.

Torque: M5, 5Nm

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that a new bolt is installed.

NOTE:

Only tighten the nuts and bolts when the suspension is in the normal drive position.

Remove the screw.

ALL VEHICLES

Courtesy of VOLVO CARS CORPORATION

Remove the cable harness clips.

VEHICLES WITHOUT AIR SUSPENSION

Courtesy of VOLVO CARS CORPORATION

Remove the following items:

Torque: Rear stabilizer bar link to stabilizer bar, 80Nm
Torque: Anti-roll bar to rear sub-frame, 35Nm

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Only use the specified special tool.

Torque: Spring seat outer, to leafspring, 70Nm

Refer to: Special Tool: 999 7560

Courtesy of VOLVO CARS CORPORATION

Assemble the following items:

Refer to: Special Tool: 951 2911
Refer to: Special Tool: 999 7560

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque: Rear shock absorber top mount, to Body, 60Nm

Courtesy of VOLVO CARS CORPORATION

Install the marked component.

Tighten the bolts.

Torque: M10, 50Nm

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure that the special tool can move freely.

Place the component where indicated in the graphic.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Only tighten the nuts finger tight at this stage.

Install the nuts

Courtesy of VOLVO CARS CORPORATION

NOTE:

Measurements achieved must correspond to values stated in the graphic.

Adjust to the specified value.

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Measurements achieved must correspond to values stated in the graphic.

Adjust to the specified value.

ALL VEHICLES

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Courtesy of VOLVO CARS CORPORATION

NOTE:

The image content (components etc.) may vary depending on equipment level or for other reasons.

Remove the nut.

Remove the marked part.