Boot, Driveshaft Constant Velocity Joint, Outer [2016-2020, B4204T23, TG-81SC | 2016-2020, B4204T23; B4204T27, TG-81SC AWD | 2016-2019, B4204T28, TG-81SC | 2020, B4204T28; B4204T39, TG-81SD]: Installation
CAUTION:
0
Only use the specified lubricant.
0
NOTE:
Make sure that a new component is installed.
Use: Plastic mallet
NOTE:
Make sure that this component is installed to the noted removal position.
CAUTION:
Make sure that there is no grease between the boot and its mating faces.
- Torque: CV-joint boot clamp, large, 24Nm
- Torque: CV-joint boot clamp, small, 17Nm
Refer to: Special Tool: 981 4201
Apply a thin and even layer.
Use: Wax, 30787812
Install the following items:
- Driveshaft left, refer to: DRIVESHAFT LEFT
- Drive shaft right, refer to: DRIVE SHAFT RIGHT