Battery Cable To The Starter Motor Control Solenoid. [2016-2020, B4204T23; B4204T27]: Removal
Removal steps in this procedure may contain installation details.
Orientation view
Set the vehicle to Inactive mode, described in user mode, refer to: USAGE MODE
Remove the following items:
- air cleaner (ACL) housing, refer to: AIR CLEANER HOUSING
- the intake manifold, refer to: INDUCTION PIPE
- Support battery, refer to: SUPPORT BATTERY
- Battery Control Switch Module BCSM, refer to: BATTERY CONTROL SWITCH MODULE BCSM
Remove the marked part.
Remove the nut.
Torque: Generator B+ terminal, 15Nm
Loosen the clips.
Loosen the wiring harness or move it to the side.
Fold marked part aside.
Remove the nut.
Torque: Starter motor B+ terminal, 11Nm
Loosen the clips.
Loosen the wiring harness or move it to the side.
Remove the following items:
- Remove the nut.
Torque: M8, 24Nm
- Remove the screw.
Torque: M8, 24Nm
Remove the screw.
Torque: M5, 5Nm
Remove the marked part.
Remove the screw.
There are two separate torque specifications, note year range.
- Torque: [2016-2017] Battery box, to Body, 13Nm
- Torque: [2018-2020] Battery box, to Body, 7Nm
Loosen the clip.
Remove the marked part.
Remove the screws.
There are two different torque specifications, not year ranges
- Torque: [2016-2017] Battery box, to Body, 13Nm
- Torque: [2018-2020] Battery box, to Body, 7Nm
Loosen the wiring harness or move it to the side.
Remove the marked part.
Release the locks.
Fold marked part aside.
Remove the nut.
Torque: M8, 24Nm
Loosen the wiring harness or move it to the side.
Release the locks.
Remove the marked part.
Loosen the clips.
Remove the screw.
Torque: M5, 5Nm
Note the routing of the lines and hoses.
Remove the marked part.