Rear Upper Arm [2016-2020]: Installation

VEHICLES WITHOUT AIR SUSPENSION

Courtesy of VOLVO CARS CORPORATION

Refer to: Special Tool: 999 7560

Tighten the nut.

Torque: Spring seat outer, to leafspring, 70Nm

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque: Rear shock absorber top mount, to Body, 60Nm

Courtesy of VOLVO CARS CORPORATION

Install the marked component.

Tighten the bolts.

Torque: M10, 50Nm

Courtesy of VOLVO CARS CORPORATION

Assemble the following items:

Refer to: Special Tool: 951 2911
Refer to: Special Tool: 999 7560

Courtesy of VOLVO CARS CORPORATION

Place the component where indicated in the graphic.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Only tighten the nuts finger tight at this stage.

Install the nuts

Courtesy of VOLVO CARS CORPORATION

NOTE:

Measurements achieved must correspond to values stated in the graphic.

Adjust to the specified value.

VEHICLES WITH AIR SUSPENSION

NOTE:

Only tighten the nuts and bolts when the suspension is in the normal drive position.

See information about normal position, refer to: NORMAL POSITION

ALL VEHICLES

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that new bolts are installed.

Install the marked component.

Install the screws.

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that a new nut is installed.

Install the nut.

Torque:Upper arm rear to subframe,

Stage 1: 50Nm
Stage 2: 120 °

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Make sure that a new nut is installed.

Install the nut.

Torque: Rear upper control arm to wheel knuckle, 60Nm

VEHICLES WITHOUT AIR SUSPENSION

Remove the Special Tool.

To install, reverse the removal procedure.

VEHICLES WITH AIR SUSPENSION

Fill air springs according to: Diagnostics/ Components/ ECU / SUM / Diagnostic Sequences / Deflating and filling air springs and reservoir

To install, reverse the removal procedure.