Seat Track Front Seat [2016-2020]: Removal

NOTE:

Removal steps in this procedure may contain installation details.

Remove quick-coupling belt, refer to: SAFETY BELT ANCHOR QUICK RELEASE

Courtesy of VOLVO CARS CORPORATION

Torque: Front seat to body, 40Nm

Loosen the screws.

APPLIES TO EXCELLENCE

Courtesy of VOLVO CARS CORPORATION

NOTE:

The graphic shows the back of the component before removal.

VEHICLES LATE VERSION

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Use: Interior trim remover

ALL VEHICLES

Courtesy of VOLVO CARS CORPORATION

Torque: Front seat to body, 40Nm

Loosen the screws.

Courtesy of VOLVO CARS CORPORATION

Courtesy of VOLVO CARS CORPORATION

CAUTION:

The number of connectors, cables and cable ties may vary depending on the vehicle specification.

Disconnect the connector.

Remove the fastener.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

Courtesy of VOLVO CARS CORPORATION

NOTE:

The component has a left-hand thread.

Torque: M5, 5Nm

Loosen the screws.

Courtesy of VOLVO CARS CORPORATION

Torque: M5, 5Nm

Loosen the screws.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Torque: Seat track, to seat, 22Nm

Remove the screws.

On both sides.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

VEHICLES WITH POWER SEATS

Courtesy of VOLVO CARS CORPORATION

NOTE:

Extra cable length must be secured using cable ties.

Disconnect the connector.

Remove the fasteners.

Courtesy of VOLVO CARS CORPORATION

Torque: Seat track, to seat, 22Nm

Remove the screws.

On both sides.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Remove the fasteners.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

ALL VEHICLES

Courtesy of VOLVO CARS CORPORATION

NOTE:

The following steps are only necessary when installing a new component.

Torque: Bracket, to Seat track, 26Nm

Loosen the screws.

Remove the marked part.