Removal And Installation
REMOVAL
Removal steps in this procedure may contain installation details.
Make sure to replace the marked component with a new.
Remove seat, rear (excellence), refer to: SEAT, REAR EXCELLENCE)
Use a drill with the stated size
Repeat on the other side.
Release the catch.
Remove the part carefully
Repeat on the other side.
Disconnect the connectors.
Use: Interior trim remover
Remove the part carefully
Repeat on the other side.
Remove the panel.
Remove the marked part.
Remove the cable harness clips.
Torque: Panel, partition wall, for bracket, 8Nm
Remove the screws.
Remove the marked part.
Remove the marked part.
On both sides.
Remove the screws.
Remove the marked part.
On both sides.
Remove the screws.
- Torque: Floor console, to Body, 11Nm
- Torque: M5, 5Nm
Remove the screws.
On both sides.
The graphic shows the back of the component before removal.
Remove the panel.
Remove the screws.
Make sure that the sharp edge does not damage the surrounding component.
Remove the marked part.
Make sure that the sharp edge does not damage the surrounding component.
Disconnect the connector.
Remove the marked part.
Remove the marked part.
On both sides.
The graphic shows the back of the component before removal.
Remove the marked part.
Torque: Refrigerator panel, to Bracket, 6Nm
Remove the screws.
Make sure that the sharp edge does not damage the surrounding component.
Remove the screws.
Remove the marked part.
Torque: M6, 10Nm
Remove the screw.
Remove the clips.
Remove the marked part.
On both sides.
Torque: M6, 10Nm
Remove the nuts.
Torque: Bracket, to Ceiling, 8Nm
Remove the screws.
On both sides.
Remove the marked part.
Torque: M6, 10Nm
Remove the nuts.
Remove the marked part.
Torque: M6, 10Nm
Remove the nuts.
Remove the marked part.
Remove the marked part.
Remove the marked part.
Remove the marked part.
Remove the marked part.
Remove the marked part.
Remove side panel cargo compartment (excellence), refer to: LOAD SPACE SIDE PANEL
APPLIES TO THE RIGHT-HAND SIDE
Remove the screws.
Disconnect the connector.
Remove the marked part.
APPLIES TO THE LEFT-HAND SIDE:
Torque: Load floor support, to Body, 6Nm
Remove the screws.
Remove the marked part.
ALL VEHICLES
Torque: M6, 10Nm
Remove the screws.
Torque: M6, 10Nm
On both sides.
Remove the screw.
Remove the cable harness clips.
Torque: M5, 5Nm
Remove the nut.
HINT: This step may require the aid of another technician.
Torque: Partition wall, to Body, 40Nm
Remove the screws.
Torque: Partition wall, to Body, 40Nm
On both sides.
Remove the screws.
Torque: Partition wall, to Body, 40Nm
Remove the screw.
On both sides.
This step requires the aid of another technician.
Remove the marked part.
TRANSFERRING COMPONENTS
Remove the marked part.
The item is to be reused.
Release the catches.
Remove the marked part.
The item is to be reused.
Remove the marked part.
The item is to be reused.
The part is not to be reused.
Make sure to replace the marked component with a new.
INSTALLATION
Use: Double-sided tape, 31299109
Remove any tape or tape residue.
Clean the marked area.
Note position of components.
Install the marked component.
Install the marked component.
To install, reverse the removal procedure.