Accessory Installation
EQUIPMENT
COMPONENT OVERVIEW
INFORMATION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.
COLOR SYMBOLS
This color chart displays (in color print and electronic version) the importance of the different colors used in the images of the method steps.
- Used for focused component, the component with which you will do something.
- Used as extra colors when you need to show or differentiate additional parts.
- Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.
- Used when the component is not fully removed from the vehicle but only hung to the side.
- Used for standard tools and special tools.
- Used as background color for vehicle components.
FURTHER INFORMATION
When installing, the car must retain a temperature of 20 degrees C.
There may be parts in the accessories kit that are not needed for this installation.
VEHICLES WITH INTEGRATED EXHAUST END PIPES
REMOVAL
Remove the screws.
Remove the clips.
Detach the panel.
On both sides.
Use: Interior trim remover
VEHICLES WITH PARKING ASSISTANCE
The graphic shows the back of the component before removal.
The part is to be reused.
ALL VEHICLES
Remove the panel.
Remove the screws.
On both sides.
Remove the part carefully
ACCESSORY INSTALLATION
Install component that comes with the accessory kit.
On both sides.
Install the screws.
On both sides.
Reinstall the removed parts in reverse order.
APPLIES TO VEHICLES WITH DOUBLE END PIPE
The end pipes must be installed together with the diffuser.
Install component that comes with the accessory kit.
On both sides.
Install the screws.
On both sides.
APPLIES TO VEHICLES WITH SINGLE END PIPE
The end pipes must be installed together with the diffuser.
Install component that comes with the accessory kit.
On both sides.
Install the screws.
On both sides.