Checking Components And Wiring
CAUTION:
Do not touch the terminal pins in the supplemental restraint system module (SRS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS).
- Switch off the ignition. Wait 10 seconds
- Disconnect the connector from the switch for the passenger airbag
- Disconnect the connector from the supplemental restraint system module (SRS).
Check the connectors for the switch and the supplemental restraint system module (SRS). Check for damage to pins and terminals in the connectors.
Remedy as necessary.
Check the cable between the supplemental restraint system module (SRS) and the switch connector. Check for a short-circuit to supply voltage.
Check the cable between:
- Supplemental restraint system module (SRS) terminal #45 and switch connector terminal #4
- Supplemental restraint system module (SRS) terminal #50 and switch connector terminal #5.
Remedy as necessary.
Other information
- see CONNECTING THE BREAKOUT BOX
- For -2004, see SIGNAL SPECIFICATION or for model year 2005-, see SIGNAL SPECIFICATION
- see SUPPLEMENTAL RESTRAINT SYSTEM MODULE (SRS), REPLACING
- To access or replace the switch for the passenger airbag and the connectors, see: CONTACT BREAKER PASSENGER AIRBAG (SRS), REPLACING
- see CABLE HARNESS SRS SYSTEM, REPAIR
- see CHECKING WIRING AND TERMINALS
- Continue
See: VERIFICATION