Checking Components And Wiring
Control module and rear reading lamp module
Check the cable between control module terminal #15 and rear reading lamp module terminal #2. Check for an open-circuit.
Check the cable between control module terminal #14 and rear reading lamp module terminal #6. Check for an open-circuit.
Control module and roof lamp module
Check the cable between the control module terminal #8 and roof lamp module terminal #2A. Check for an open-circuit. Check for a short-circuit to ground.
Control module and right/left vanity mirror lighting
Check the cable between control module terminal #8 and right/left vanity mirror lighting terminal #1. Check for an open-circuit. Check for a short-circuit to ground.
Check the cable between control module #20 and right/left vanity mirror lighting #3. Check for an open-circuit.
Remedy as necessary.
If no fault is found, try replacing the module that is malfunctioning.
This could be:
- Rear reading lamp module
- Roof lamp module
- Right/left vanity mirror lighting.
Other information
- For further information about signals and other values, see SIGNAL DESCRIPTION, UPPER ELECTRONIC MODULE (UEM)
- To connect the breakout box, see CONNECTING THE BREAKOUT BOX
- To access the vanity mirror lighting, see BULB VANITY MIRROR, REPLACING
- To access or replace the roof lamp module, see INTERIOR LIGHTING, REPLACING
- To access or replace the rear reading lamp module, see BULB, READING LAMP, REAR, REPLACING
- see CHECKING WIRING AND TERMINALS .