Installing Sun Roof
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2011 Volvo XC90, 2010 Volvo XC90, 2009 Volvo XC90, 2008 Volvo XC90, and 2007 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For tightening torques, see TIGHTENING TORQUE .
HINT: Install the screws, the spacers and the nylon washer for the gutter frame before installation.
Install:
- the 2 M6*35 screws (position 1)
- the 2 M6*25 screws (position 2)
- the 2 M6*20 screws (position 3)
- the 2 M6*16 screws (position 4)
- the 2 spacers, 20*6, 5*19.3 mm (positions 1 and 2)
- the 2 spacers, 20*6, 5*9.6 mm (positions 2 and 2)
- the 4 spacers, 20*6, 5*4.4 mm (positions 3 and 4).
Lift the sun roof. Place the sun roof in position.
Tighten.
Install:
- the drainage
- the connector.
Adjust. See SUN ROOF, ADJUSTING .
Install the headlining. See HEADLINING, REPLACING .
Check for leakage. See SUN ROOF, LEAK TEST .