Removing Seat Airbag Modules (Sips)
Remove the seat from the vehicle. See REMOVING THE FRONT SEAT (-2004) or FRONT SEAT, REPLACING (2005-).
Release the tension in the lumbar support.
Remove:
- the lumbar support knob. See LUMBAR SUPPORT BACKREST CUSHION, REPLACING (-2004) or LUMBAR SUPPORT BACKREST CUSHION, REPLACING (2005-)
- the side piece by pulling it straight out
- the backrest adjustment knob. This applies only to manual seats
- the 5 half moon clips from the bottom of the backrest.
Remove the upholstery up to the first lateral channel. There are 2 half moon clips on each front-rear channel.
Remove 3 half moon clips from the first lateral channel.
Remove another half moon clip from each side of the front-rear channels up to the upper front-rear channel.
Remove the 2 elastic attachments on the inside/reverse of the backrest.
Pull up the backrest upholstery.
Bend out and expose the protective pad on the side where the airbag is located.
Remove the 2 screws holding the airbag to the inside of the backrest frame.
Pull the airbag downwards. Fold the airbag slightly forward.
Remove the airbag.
Cut the tie strap.
Cut off the 2 tie straps.
Release the cable harness.
Replace the airbag.