Wheel Hub Rear, Checking [2009-2017]
SPECIAL TOOLS
| T9995418 MEASURING INSTRUMENT KIT (HUB AND BRAKE DISC RUNOUT, B-VER) Tool number: T9995418 Tool description: MEASURING INSTRUMENT KIT (HUB AND BRAKE DISC RUNOUT, B-VER) |
NOTE:
Removal steps in this procedure may contain installation details.
Remove the brake disc. Refer to REAR BRAKE DISC
Refer to Special Tool: 999 5418
Fit the bracket that is part of the measuring equipment. Use the brake caliper's retaining screws.
Fit the dial indicator in the bracket. Position the dial indicator's tip toward the hub flange.
Slowly rotate the hub. The maximum lateral runout of the hub should not exceed 0.014 mm.
If lateral runout exceeds 0.014 mm, replace the hub. Refer to REAR WHEEL HUB
To ensure that the max. value together with the brake disc is not exceeded, check the lateral runout of the brake disc. Refer to BRAKE DISC REAR, CHECKING
To install, reverse the removal procedure