Checking Signal Cables

Check the connector for the solenoid on the steering gear. Check for contact resistance and oxidation.

Check for damage carefully.

Check the signal cable between the control module for speed related power steering terminal #5 and the solenoid connector terminal #1. Check for an open-circuit. Check for a short-circuit to supply voltage. Check for a short-circuit to ground.

Check the signal cable between the control module for speed related power steering and the solenoid connector terminal #2. Check for an open-circuit. Check for a short-circuit to supply voltage. Check for a short-circuit to ground.

Remedy as necessary.

Other information 

• To access the solenoid connector, see STEERING GEAR, REPLACING
• see CHECKING WIRING AND TERMINALS .

Fig 1: Identifying Injector Connector Terminals

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS CORPORATION

Was a fault detected? 

• YES 

  Refer to VERIFICATION 

• NO 

  Refer to REPLACING COMPONENT