Checking The Ground Terminals: Verification

HINT: After the repair it is necessary to check that the fault has been rectified. 

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS CORPORATION

• Ignition off.
• Control unit disconnected.
• Switch off all battery loadings such as entrance lighting and radio.

  Connect an ohmmeter between the battery negative lead and test box 14.

  Additional information 

  • To connect the test box, see CONNECTING THE DRIVER INFORMATION MODULE (DIM) TEST BOX
  • For information on signals and additional values, see DRIVER INFORMATION MODULE (DIM) SIGNAL DESCRIPTION .
  Fig 2: Breakout Box

  Courtesy of VOLVO CARS CORPORATION
  Fig 3: Identifying Ohmmeter

  Courtesy of VOLVO CARS CORPORATION

The ohmmeter should display approximately 0. 

• OK 

  VERIFIED:  Troubleshooting has been completed.

• NOT OK 

  Refer to INFORMATION