Installing The Brake Pipe Junction / Abs Unit
NOTE:
For tightening torques, see: TIGHTENING TORQUE .
NOTE:
The new brake pipe must be bent into the correct shape when installing. This is important otherwise the pipe may be subject to stresses when it is in place.
Remove the cut-off brake pipe. Install the new one.
Tighten the brake pipe in the joint nipple. Tighten. See: TIGHTENING TORQUE .
Secure the brake pipe in its clips in the body floor.
Bend and adjust the brake pipe so that it aligns with the hydraulic unit.
Install:
- the brake pipe in the ABS hydraulic modulator. Tighten. See: TIGHTENING TORQUE
- the brake pipe in its clips at the bracket. Adjust the pipe as necessary
- the clip holder on the brake pipes by the side member
- the bracket. Tighten. See: TIGHTENING TORQUE .
NOTE:
The brake pipes must not be in contact with each other or the car body.