Front Bumpers
NOTE:
Applies to trim panels that are only primed.
CAUTION:
The trim panel is manufactured of a PUR plastic which is very malleable. If the plastic part is not adequately supported in storage or when mounted during painting then there is significant risk that the plastic will change shape. Guide pins or other protruding parts must not bear the weight of a plastic part. Lay the plastic parts with support across a wide area. The malleability will be even greater when heated. Drying in an oven must not be used in temperatures above 50 C. The best method is to allow the plastic parts to dry in the air.
- Detach the existing bumper by carefully prizing at the lower edge, between bumper and bumper cover, using a plastic weatherstrip tool. Following which, pull the bumper straight out so that the catches release.
- Align the new bumper from the kit and press it in.NOTE:
Make sure that all of the catches engage.