Checking The Ignition Switch

Check that the ignition lock or key does not have any mechanical faults that can prevent starts.

• Insert the key and check that it locks properly.
• Remove the key and check that it does not jam or stick. If the message is not correctly received try with another key. If this also jams, slacken off and pull out the securing bolts on the Start control module (SCU).

If mechanical problems persist, replace the Start control module (SCU).

Was a fault detected? 

• YES 

  Refer to VERIFICATION 

• NO 

  Refer to CHECKING THE DIAGNOSTIC TROUBLE CODES (DTCS) 

• Remove the key from the ignition switch.
• Erase diagnostic trouble codes by clicking the VCT2000 (Volvo Scan Tool) symbol.
• Insert the key in the ignition switch.

Fig 1: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

Courtesy of VOLVO CARS CORPORATION

Does the engine pull the key to the correct position? 

• YES 

  Refer to CHECKING THE IGNITION SWITCH 

• NO 

  Refer to CHECKING CABLE HARNESS 

Ensure that the key locks in the locked position in the ignition switch. If not, read out the DTCs and fault-trace according to the relevant DTC information.

Click on the VCT2000 (Volvo Scan Tool) symbol to read off diagnostic trouble codes (DTCs).

• If the key does not jam and there are no DTCs related to the start system stored, replace the Start control module (SCU).

Fig 1: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

Courtesy of VOLVO CARS CORPORATION

Do you wish to continue with symptom fault tracing? 

• YES 

  Refer to CHECKING THE POSITION OF THE IGNITION KEY 

• NO 

  OKAY:  Troubleshooting has been completed.