USB/IPOD Music Player: Notes
- Turn the ignition key to position 0.
NOTE:
Wait at least three minutes before unplugging the connectors or removing other electrical equipment.
- Remove the surround from around the display and media player: Use a small screwdriver and press in the catch on one of the surround's upper corners. Carefully bend loose the surround on the same side with a plastic weatherstrip tool.
NOTE:
Do not damage the panel and dashboard.
- Repeat the procedure for the other side and then fold the surround backwards into the vehicle. Pull the surround up until it detaches.
HINT: If the panel is difficult to remove, press the panel on both sides again and repeat the procedure starting at the other side.
- Remove the ignition control module (ICM). It is secured by hidden clips, 2 pcs.
HINT: Grip with both hands and pull.
- Disconnect the two connectors. Put the display to one side.
- Apply the handbrake.
- Detach the panel by prying it up (1) using a weatherstrip tool and then pull it off outwards (2).
- Fold up the tunnel console's armrest and remove the cover at the bottom.
- Remove the two screws.
- Remove the two screws along the front edge of the tunnel console.
- Remove the front storage compartment by prying it off at the front edge using a weatherstrip tool and lifting it out.
- Carefully lift the catches at the front edge of the tunnel console.
HINT: Use special tool, P/N 9995919.
- Hold up the lock catch and at the same time slide the entire tunnel console back 20 mm, so that the two rear screws in the center console are accessible.
- Remove the two screws.