Adjusting The Protective Cover

Fig 1: Locating Snap Fasteners

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut off two of the snap fasteners (1).

Fig 2: Identifying Snap Fastener

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Locating Drill Location

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use a 5 mm bit to drill two holes - one on each side - just below where the snap fasteners previously were.

Fig 4: Identifying Cable Ties

Courtesy of VOLVO CARS OF NORTH AMERICA.

Locate the holes in the member for both cable ties. Insert one cable tie through one of the holes and do the same on the other side.

Fig 5: Inserting Cable Tie Through Hole

Courtesy of VOLVO CARS OF NORTH AMERICA.

Before fitting the protective cover against the member, insert the cable ties through the drilled holes.

Fig 6: Tightening Cable Ties

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press the protective cover against the member and make sure the snaps lock against the member. Finish by tightening the cable ties and cutting of the excess.