Reverse Warning System: Removal
Courtesy of VOLVO CARS OF NORTH AMERICA.
- Remove the 3 mounting screws / clips for the splashguards
- Remove the screw (A)
- Press in the catch. Disconnect the connector for the side marker lamp in the rear bumper
- The procedure is the same for both the left and right hand sides.
Courtesy of VOLVO CARS OF NORTH AMERICA.
- Remove the nuts (A and B). Remove the screw (C)
- Carry out procedures A, B and C on both the right and left-hand sides
- Up to chassis number 600000: Remove the clip (D) from the underneath of the bumper
- Apply tape under the tail lamps to protect against damage to the paint work when removing the rear bumper
- Remove the rear bumper.