Collision Protection Unit From Behind Front Seat: Notes
Removal steps in this procedure may contain installation details.
Only for vehicles with fixed backrest.
Remove the front seat according to: FRONT SEAT .
The operation must be carried out on both sides of the seat.
On both sides.
On both sides.
Torque: Backrest cushion to seat cushion
45 Nm
.
Loosen and move aside the backrest upholstery acc. to: FRONT SEAT BACKREST (2006-2011)or FRONT SEAT BACKREST (2012) .
Take extra care when handling the compressed spring.
Torque: Fitting bolt, hinge
18 Nm
.
Torque: Hinge bracket to backrest
9 Nm
.
Only for vehicles with folding backrest.
Remove the front seat according to: FRONT SEAT .
The operation must be carried out on both sides of the seat.
On both sides.
On both sides.
Torque: Backrest cushion to seat cushion
45 Nm
.
Loosen and move aside the backrest upholstery acc. to: FRONT SEAT BACKREST (2006-2011)or FRONT SEAT BACKREST (2012) .
Take extra care when handling the compressed spring.
Torque: Fitting bolt, hinge
18 Nm
.
Special tools:
see 9512943
The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.
Special tools:
see 9512943
The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.