Remove / Install

Fig 1: View Of Protective Cushion In Position

Courtesy of VOLVO CARS CORPORATION

Take the protective cushion and locate the child seat in its correct position with the protective cushion between the seat's backrest and the dashboard. The lower edge of the protective cushion must be approximately edge to edge with the lower edge of the dashboard.
Mark out the lower edge of the protective cushion on the end face of the seat with a strip of tape.

Fig 2: Washing Back Of Child Seat

Courtesy of VOLVO CARS CORPORATION

Wash the back of the child seat for affixing the Velcro strap using a mixture of 30% washer fluid and 70% water as indicated by the marking.
Wipe dry.

Fig 3: Identifying Protective Cushion Velcro Strap

Courtesy of VOLVO CARS CORPORATION

Pull off one Velcro strap from the protective cushion.
NOTE:
Do not pull only on the white protective tape.

Fig 4: View Of Velcro Strap On The Centre Of Backrest

Courtesy of VOLVO CARS CORPORATION

Pull off the protective tape from the detached Velcro strap.
Press the Velcro strap into the center of the backrest and according to the tape marking in the lower edge.
Press the protective cushion into the seat's backrest.
Remove the tape marking.