Checking Components And Wiring
- Ignition off
- Disconnect the connector from the front left side impact sensor
- Disconnect the connector from the front right side impact sensor.
Check the resistance between terminals #8A (8) and #9C (5) in the Supplemental Restraint System Module (SRS) connector. The resistance must be infinite.
Check the resistance between terminals #9A (9) and #9C (5) in the Supplemental Restraint System Module (SRS) connector. The resistance must be infinite.
Check the resistance between terminals #8A (8) and #8C (4) in the Supplemental Restraint System Module (SRS) connector. The resistance must be infinite.
Check the resistance between terminals #9A (9) and #8C (4) in the Supplemental Restraint System Module (SRS) connector. The resistance must be infinite.
Remedy as necessary.
Other information:
- To access and replace the SRS control module and connector, see SUPPLEMENTAL RESTRAINT SYSTEM MODULE (SRS), REPLACING
- To connect the breakout box, for model year 2003-2004 see CONNECTING THE BREAKOUT BOX or for model year 2005- see CONNECTING THE BREAKOUT BOX
- To access or replace the side impact sensor, see COLLISION SENSOR B AND C-POST, REPLACING
- For information about the repair of SRS wiring, see CABLE HARNESS SRS SYSTEM, REPAIR
- For information about signals, -2004, see SIGNAL SPECIFICATION or for 2005- see SIGNAL SPECIFICATION
- see CHECKING WIRING AND TERMINALS .
- Continue
See: VERIFICATION