Checking Components And Wiring
- Ignition off
- Disconnect special tool
see 9511506
from the connector for seat belt tensioner.WARNING:
Under no circumstances use an ohmmeter or other live measuring instrument to take readings from a disconnected undeployed seat belt tensioner. This could deploy the seat belt tensioner
CAUTION:Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.
Check the cable between the Supplemental Restraint System Module (SRS) terminal #13C(9), terminal #14C(10) and connector terminal #1, terminal #3 on the right seat belt tensioner on the 3rd seat row. Check for a short-circuit to ground.
Connect special tool see 9511506 to the connector for seat belt tensioner.
Check the resistance between terminals #13C(9), #14C(10) to the Supplemental Restraint System Module (SRS). The resistance between the terminals should be infinite.
Remedy as necessary.
Other information:
- To access and replace the SRS control module and connector, see SUPPLEMENTAL RESTRAINT SYSTEM MODULE (SRS), REPLACING
- To access and replace the switch for the seat belt tensioner, see SEAT BELT FRONT, REPLACING or SEAT BELT REAR, REPLACING
- To connect the breakout box, see CONNECTING THE BREAKOUT BOX
- For information about the repair of SRS wiring, see CABLE HARNESS SRS SYSTEM, REPAIR
- For information about signals, see SIGNAL SPECIFICATION
- see CHECKING WIRING AND TERMINALS .
- Continue
See: VERIFICATION