Checking The Component

Measure the resistance between pins terminals #8 and #6 on the chassis switch lock unit.

The ohmmeter should read approximately 5 ohm.

Other information 

• To remove the lock unit, see LOCK MECHANISM, TAILGATE, REPLACING
• For information about signals, see SIGNAL SPECIFICATION .

Fig 1: Identifying Ohmmeter

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Connector Terminals

Courtesy of VOLVO CARS CORPORATION

Is the value correct? 

• YES 

  Refer to FUNCTION TEST 

• NO 

  Refer to REPLACING THE COMPONENT 

Measure the resistance between pins terminals #7 and #6 on the chassis switch lock unit.

The ohmmeter should read approximately 5 ohm.

Other information 

• To remove the lock unit, see LOCK MECHANISM, TAILGATE, REPLACING
• For information about signals, see SIGNAL SPECIFICATION .

Fig 1: Identifying Ohmmeter

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Connector Terminals

Courtesy of VOLVO CARS CORPORATION

Is the value correct? 

• YES 

  Refer to FUNCTION TEST 

• NO 

  OKAY:  Troubleshooting has been completed.