Circuit Test Continued

Measure the resistance between terminal #1 and ground and between terminal #2 and ground on the cable connector.

The ohmmeter should read 0 ohm.

1. The ohmmeter displays a fault between terminal #1 and ground. Refer to CHECKING THE UNLOCKING RELAY CIRCUIT .
2. The ohmmeter displays a fault between terminal #2 and ground. Refer to CHECKING THE LOCKING RELAY CIRCUIT 

Fig 1: Identifying Connector Terminals

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS CORPORATION