Parking Assistance, Rear: Installation
- Locate the two studs for the control module.
- Take the holder for the control module from the kit. Press it onto the studs.
- Disconnect the light brown connector that is taped to the car's existing cable harness.
- Remove the rubber plug.
- Take the cable harness from the kit and route it through the hole. Install the rubber grommet.
- Hook the connector onto the rail.
- Take the control module from the kit and connect the connectors.
- Press the control module on the holder.
- Check which holders are to be positioned where before installation. Each holder is marked and has its own location.
- Apply two pieces of tape to the holder.
- Remove the protective film from the tape.
- Apply a thin and even layer of adhesive to a holder. The adhesive must be above the tape level.NOTE:
The adhesive must not come into contact with the tape.
The task of the tape is to secure the holders to the bumper casing until the adhesive has hardened after approximately 24 hours.
- Install the centering tool in the holder.
- Install the tool on the bumper cover.
- Press the holder towards the casing, but only at the places where there is tape.
- Hold the holder securely when removing the centering tool. The holder must be installed horizontally and in line with the bumper cover.
- Repeat steps until all four holders are in place.
- Connect the cable harness connectors to the sensors.
- Install the sensors in their holders. Take care not to release the holders from the tape when installing.NOTE:
The large gray connector must protrude from the right-hand side of the bumper cover.
- Attach the cable holders to the covers flanges.