Install the cross members and heat shield
Pull back the rear heat deflector to line up with the holes.
Blind rivet the heat deflector to the cross member
Install the screws, nuts and heat deflector on the rear cross member. Tighten all screws and nuts to 25 Nm .
Remove the pedal jack.
Fill and bleed the brake system
See Brake system, bleeding (using bleeding unit)
Pressure test the brake system
Fig 2: Depressing Brake Pedal As If Braking Suddenly (So That Wheels Would Almost Lock) For 30 Seconds
After the brake system has been bled it must be pressure tested.
Depress the brake pedal as if braking suddenly (so that the wheels would almost lock) for 30 seconds. Check that no leakage occurs from the brake nipples, hoses and joints.
Remedy any leakage.
Install the wheel