Collision Protection Unit From Behind Front Seat: Installation
NOTE:
For tightening torques, see: TIGHTENING TORQUE .
INSTALLING THE WHIPLASH UNIT ON NON-FOLDING SEATS
Install a new whiplash element.
Install:
- a new spring
- the bracket
- a new Torx screw and tighten. See: TIGHTENING TORQUE
Install:
- the shaft
- the bushing
- the lock nut; tighten the M8 screw and the nut. See: TIGHTENING TORQUE .
Slide the entire whiplash unit up towards the backrest frame.
Hook on the spring using see 9512943 .
Reinstall the upholstery.
Install:
- the 4 x M10 screws for the backrest frame
- the cover
- the side panel.
NOTE:
For tightening torques, see: TIGHTENING TORQUE .
INSTALLING THE WHIPLASH UNIT ON FOLDING SEATS
Install a new whiplash element.
Install:
- a new spring
- the locking washer.
Install:
- the shaft
- the bushings
- the lock nut, tighten the M8 screw and the nut. See: TIGHTENING TORQUE .
Slide the entire whiplash unit up towards the backrest frame.
Hook on the spring using see 9512943 .
Reinstall the upholstery.
Install:
- the 4 x M10 screws for the backrest frame
- the cover
- the side panel.
NOTE:
For tightening torques, see: TIGHTENING TORQUE .
Install in the reverse order.