Microphone Telephone: Removal

NOTE:

Removal steps in this procedure may contain installation details.

Make sure that the vehicle is modified according to microphone telephone, modification, see CELLULAR TELEPHONE MICROPHONE, MODIFICATION

Fig 1: Identifying Ignition In OFF Position

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Microphone Telephone

Courtesy of VOLVO CARS CORPORATION

Fig 3: Remove/Install Visor and Clip

Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Rearview Console Bezel

Courtesy of VOLVO CARS CORPORATION

Fig 5: Identifying Sun Visor Components

Courtesy of VOLVO CARS CORPORATION

Torque: M6

10 Nm

Remove panel A-pillar, see A-PILLAR TRIM PANEL

Fig 6: Identifying Headliner Trim

Courtesy of VOLVO CARS CORPORATION

Fig 7: Locating Grab Handle Screws

Courtesy of VOLVO CARS CORPORATION

Torque: M6

10 Nm

Fig 8: View Of Headliner

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Take extra care not to crease the headliner.

Fig 9: Anti-squeak tape, 1161842

Courtesy of VOLVO CARS CORPORATION

NOTE:

Note the position of the component before removal.

Use: Anti-squeak tape, 1161842

Fig 10: Identifying Microphone Bezel Cut Points

Courtesy of VOLVO CARS CORPORATION