Checking The Cable

HINT: The fault could also have been caused by the windshield wipers sticking. 

Check the cable between central electronic module (CEM) terminal #16B and motor (6/1) terminal #3. Check for a short-circuit to supply voltage. See SHORT-CIRCUIT TO SUPPLY VOLTAGE. PERMANENT FAULTS . Check for an open-circuit. See OPEN-CIRCUIT, PERMANENT FAULTS .

Check the connector.

If no other faults are found try a new windshield wiper motor (6/1).

Remedy as necessary.

Other information: 

• To connect the breakout box, see CONNECTING THE BREAKOUT BOX
• For information about signals, see SIGNAL SPECIFICATION
• To replace the wiper motor, see MOTOR WINDSHIELD WIPER, REPLACING .

Fig 1: Identifying Ohmmeter

Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to VERIFICATION